MDS TransNET 900 Manuale Utente Scaricare il pdf (Pagina 11)

APPLICATION NOTE: Using Wind Observer II with MDS Trans NET 900 Radio 11

CONFIGURING THE WIND OBSERVER II WITH A PC TERMINAL

In order to configure the Wind Observer II, you must use a terminal application such as HyperTerminal in

Windows. To open this program, go to: Start>All programs>Accessories>Communications>Hyper

Terminal.

Specifics “Commands” can be used to operate and configure the

Wind Observer II. A User commands list is included on the Web site

provided at the beginning of this application note. User

commands used in this application notes will be necessary to

configure the Wind Observer II for our purpose.

Once connected, we should be able to communicate to the Wind

Observer II via Hyper Terminal. The parameters of communication

in the PC for the Port Settings Tap in the Hyper Terminal

configuration are:

 Bits per second: 9600

 Data Bits: 8

 Parity: None

 Stop Bits: 1

 Handshaking: none.

At this point we should be able to communicate with the Wind Observer II. To access to the command

interface, press ENTER key, until the Wind Observer II respond with wind measurements. The Wind

Observer II is set to MEASUREMENT MODE by default.

1 2 ... 6 7 8 9 10 11 12 13 14

Nessun commento

MDS TransNET 900 Manuale Utente Pagina 11