APPLICATION NOTE: Using Wind Observer II with MDS Trans NET 900 Radio 7
The MDS Trans NET 900 radio comes with four LEDs indicators in the front panel. These LEDs indicate the
operating status of the MDS Trans NET 900 radio which makes them very helpful when we are testing the
MDS Trans NET 900 radio
LED Indicators
PWR Continuous- Power is applied to the radio; no problems detected
Flashing- (5 times per second) Fault indication
Off- Radio is unpowered or in sleep mode
SYNC Continuous- Radio is receiving/sending synchronization frames
On within 10 seconds of power-up under normal conditions
TXD
Transmit data activity on the DB-9 data interface connector.
Payload data to connected device
RXD
Receive data activity on the DB-9 data interface connector.
Payload data to connected device PC.
POWERING AND CONNECTING THE MDS TRANS NET 900 RADIO
Power: Plug the power supply into the MDS Trans NET radio. A power connector with screw-terminal is
provided. The left pin is positive; the right negative
Antenna: Connect a suitable antenna to the TNC connector.
CONFIGURING THE MDS TRANS NET WITH A PC TERMINAL
In order to configure the MDS Trans NET 900 radio, you must use a terminal application such as
HyperTerminal in Windows. To open this program, go to: Start>All
programs>Accessories>Communications>Hyper Terminal.
Specifics “Users Commands” can be used to operate and configure the MDS Trans NET 900 radio. A User
commands list is included on the Web site provided at the beginning of this application note. User
commands used in this application notes will be necessary to configure the MDS Trans NET 900 radio for
our purpose.
The PC must be connected to the radio’s DIAG connector using an RJ-11 to DB-9 adapter cable (0nly
for configuration).
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale