MDS MX-2104 Specifiche Scaricare il pdf (Pagina 106)

Chapter 4 Operation MX-2100/2104 Installation and Operation Manual

4-2 MX-2100 Supervision Language

• Commands are case-insensitive, e.g., you can type commands in either lower

case and/or upper case letters.

• To correct typing errors, press the BACKSPACE key until the error is cleared,

and then retype the correct command.

• Use a space as a separator between command fields and/or parameters.

• Commands must end by pressing ENTER.

• To use a command with the existing parameters, type the command name and

press ENTER.

• To cancel the current command, press the BREAK key, or CTRL-C (that is, hold

the CTRL key down and type C). You will obtain the MX-2100 prompt again.

• To repeat the previous command, press CTRL-A.

• To repeat the previous command followed by pressing ENTER, press CTRL-D.

Command Options

The following general types of options shown in Table 4-1 are available with some

commands. For details refer to the relevant appendix.

Table 4-1. General Command Options

Option Meaning Example of Usage

/A All CLR ALM /A

Clears all the alarms stored by the alarm buffer

/C Clear DSP ALM /C

Display all the alarms stored by the alarm buffer and

then clear all the event alarms

/CA Clear all DSP ALM /CA

Display all the alarms stored by the alarm buffer and

then clear all the alarms

* Display all the relevant

information for the

requested item

DSP REV *

Displays the hardware and software revisions of all the

modules installed in MX-2100

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 242 243

Nessun commento

MDS MX-2104 Specifiche Pagina 106